emonPi Solar PV
- Includes 2 x Clip-on CT sensors
- Includes AC-AC voltage sensor adatper
As funded on Kickstarter!..
Price: £137.00
↧
emonPi - Solar PV
↧
emonPi LCD Case Kit
Aluminium case kit for the emonPi. Requires assembly with T20 Torx screwdriver
Price: £36.00
↧
↧
emonPi LCD Case ONLY Kit
Aluminium case kit for the emonPi. Requires assembly with T20 Torx screwdriver.
Does NOT include emonPi, only the case in kit form.
Price: £36.00
↧
emonTx V2 PCB + emonTx V2 Jack Plug Sockets
emonTx V2.2 PCB with 5 emonTx jack plug sockets included.
All other components needed to assemble an emonTx V2 are widely available, but the jack plug sockets can be difficult to source. That is why we are offering the PCB along with the jack plug sockets.
&..
Price: £4.00
↧
Raspberry Pi Case - Black
Black ABS plastic case for the Raspberry Pi Model B+ and Pi 2 the RFM69Pi fits nicely inside
- Body Colour: Black
↧
↧
Optical Utility Meter LED Pulse Sensor
Optical pulse sensor for detecting LCD pulses from Utility Meters.
The sensor can be easily stuck on to the front surface of any utility meter with an LED pulse output. The green LED on the rear of the sensor flashes in sync with the meter pulses to indicate a succe..
Price: £15.81
↧
RJ45 Expander for DS18B20 & Pulse Sensors
A 4-port RJ45 breakout board to allow multiple one-wire DS18B20 temperature sensors on RJ45 and optical pulse.. Price: £9.75
↧
T20 ScrewDriver (for emonPi)
T20 screwdriver to fit emonPi case screws
Draper chrome vanadium steel blades hardened, tempered with phosphate finish and shot blasted tips. Moulded high polymer vulcanized rubber handles
Price: £6.00
↧
Three Channel WiFi Relay / Thermostat
Three Channel WiFi Relay / Thermostat Board is a open software/hardware multi-purpose relay board based on the ESP8266 WiFi SoC. It can control up to three AC or DC loads over the Internet.. Price: £36.00
↧
↧
AC Power Supply pack for the WiFi Relay/Thermostat Board
Includes 5V PSU unit, fuse holder, fuse, screw terminal for powering the WIFI Relay Board from 230V AC.
↧
emonPi
emonPi Home Energy Monitor version
Price: £129.20
↧
Three Channel WiFi MQTT Relay / Thermostat
Three Channel WiFi Relay / Thermostat Board is a open software/hardware multi-purpose relay board based on the ESP8266 WiFi SoC. It can control up to three AC or DC loads over the Internet.. Price: £36.00
↧
AC Power Supply pack for the WiFi Relay/Thermostat Board
Includes 5V PSU unit, fuse holder, fuse, screw terminal for powering the WIFI Relay Board from 230V AC.
↧
↧
emonTH no RF - Temperature & Humidity Node
The emonTH is an open-source, battery powered, Temperature and Humidity monitoring wireless node.
Note: Price: £21.80
↧
OOK (On-Off-Keying) Transmitter - 433Mhz
OOK (on-off-keying) transmitter. Can be used on the emonPi to control LightWaveRF plugs
- Low power consumption
- Range up to 50m
- No adjustable components
- Very stable operating frequency
- TX - Wide operating vol..
Price: £4.99
↧
Spare velcro sticky pad (for optical utility meter sensor)
1 x spare set (two pads) of velcro srticky pads for use with optical utility meter pulse sensor. Useful if sensor has to be moved around differant meters.
Price: £0.50
↧
WiFi MQTT Relay / Thermostat
WiFi Relay / Thermostat Board is a multi-purpose relay board based on the ESP8266 WiFi SoC. It can control up to three AC or DC loads over the Internet using web UI or MQTT.
↧
↧
RJ45 Extender
Female-female RJ45 extender.
Extend RJ45 optical pulse sensor or RJ45 Ds18B20 temperature senso.. Price: £1.99
↧
ESP8266 WIFI Heatpump Monitor
THIS ITEM IS OUT OF STOCK UNTIL FURTHER NOTICE
Heatpump Monitoring throughhole development kit
Please note: This is a through hole kit that requires assembly and soldering
A l..
Price: £36.40
↧
DIN Rail Mount for emonPi Enclosure
Mounting fixture to mount the emonPi on a DIN rail mounting system.
Price: £13.99
↧